HID installation Step 1

Disconnect the car battery. Remove the factory light bulbs. If your vehicle’s headlights have dust caps, please remove them as well.

HID installation Step 2

If your vehicle is equipped with headlight dust caps, drill a 1″ (24mm) hole to accommodate the wiring harness.

HID installation Step 3

Remove the xenon HID bulb from the protective casing. Be careful NOT to touch the bulb. Handle it by its plastic base. If any grease or dirt gets on the bulb wipe clean with rubbing alcohol.

HID installation Step 4

Put the bulb’s wiring harness through the dust cap (as illustrated). Insert the xenon HID bulb into your headlight and secure. Connect the spade terminals (positive & negative) to the factory headlight wiring harness.

HID installation Step 5

Insert the rubber boot (on the wiring harness) through the hole on the dust cap (which you drilled earlier).

HID installation Step 6

Connect the bulb to the ballast. The quick disconnects will “click” once fully secured.

HID installation Step 7
Find a mounting location for the ballast. Use the ballast bracket, screws or zip-ties as needed.
*Do not drill holes in the ballast box.
*Mount away from moving components.
*Mount to a secure location.
*Avoid hot areas that might lead to ballast overheat.

HID installation Step 8

Check your vehicle’s headlight fuse. Make sure it is rated at 20AMPS or higher. Replace the fuse with a 20 AMP fuse if your headlight fuse is of a lower rating.

HID installation Step 9

Reconnect the battery cables

HID installation Step 10

Turn light switch on and allow your new xenon light to run for 10 minutes.

 

Still having a problem with the light is not turning on?  Try to switch the polarity plug!  Some car may have a reverse polarity.  Make sure use electrical tape to wrap around the connector to make sure it's secured

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×